head	1.1;
access;
symbols;
locks
	mys:1.1; strict;
comment	@# @;


1.1
date	99.11.22.23.41.12;	author mys;	state Exp;
branches;
next	;


desc
@@


1.1
log
@Initial revision
@
text
@############################################################
Table of Contents
############################################################
::tableofcontents::listoffigures::listoftables::
A table of contents is produced with the \tableofcontents 
command. You put the command right where you want the table 
of contents to go; LaTeX does the rest for you. It produces 
a heading, but it does not automatically start a new page. 
If you want a new page after the table of contents, include 
a \newpage command after the \tableofcontents command. 

There are similar commands \listoffigures and \listoftables 
for producing a list of figures and a list of tables, 
respectively. Everything works exactly the same as for the 
table of contents. 

NOTE: If you want any of these items to be generated, you 
cannot have the \nofiles command in your document. 

	\addcontentsline: Add an entry to table of 
		contents etc. 
	\addtocontents: Add text directly to table of 
		contents file etc. 

############################################################
	\addcontentsline ::addcontentsline::
############################################################
\addcontentsline{file}{sec_unit}{entry} 
The \addcontentsline command adds an entry to the specified 
list or table where: 

	file	is the extension of the file on which information 
		is to be written: toc (table of contents), 
		lof (list of figures), or lot (list of tables). 
	sec_unit controls the formatting of the entry. It 
		should be one of the following, depending upon 
		the value of the file argument: 
		toc -- the name of the sectional unit, such 
			as part or subsection. 
		lof -- figure 
		lot -- table 
	entry	is the text of the entry. 
############################################################
	\addtocontents ::addtocontents::
############################################################
\addtocontents{file}{text} 
The \addtocontents command adds text (or formatting commands) 
directly to the file that generates the table of contents or 
list of figures or tables. 
	file 	is the extension of the file on which information 
		is to be written: toc (table of contents), 
		lof (list of figures), or lot (list of tables). 
	text	is the information to be written. 
@